Description Check for the presence of coliform bacteria in your drinking water with this do-it-yourself, EPA-based test kit. Since contaminated water may not smell or taste bad, the presence of potentially harmful bacteria often goes undetected. Put your water to the test with this simple do-it-yourself test kit. The presence of bacteria in drinking water indicates that treatment methods are not working properly. Features & Benefits: Fast Accurate Easy to Use Contents: (4) Bacteria Test Vial Suitable for: fresh water samples, including water from tanks taps, wells, springs, boreholes, ponds as well as rain water Total Test Time: 48 hours Directions: Take out the bacteria test vial and set upright on a flat surface. Collect water sample or turn on tap to a very slow stream. Carefully twist off cap and fill vial to 5 ml line. DO NOT OVERFILL and DO NOT SPILL the bacterial growth powder in the vial. Replace cap and twist on tightly. Shake the vial vigorously for 20 seconds. Place the capped vial upright in a warm area (70-90°F / 21-32°C) where it cannot be disturbed for 48 hrs. After 48 hrs., observe the color of the liquid without opening the vial: Purple color: Negative Result (No bacteria were detected). Yellow Color: Positive Result (It is highly likely that potentially harmful bacteria were detected). For positive results, add bleach to the sample before pouring down the toilet, then wash hands carefully. Negative samples may be poured directly into the toilet. Discard vial in the trash. If your water tests outside the desired values, call your water supplier immediately. Please note: The instructions describe that the test should be kept at 70-90°F – this relates to 21-32°C. Keep tests out of reach of children or pets. Do not ingest anything from this test kit. Do not drink water sample used for testing. Store and use at room temperature (60-86°F / 16-30°C). Do not use on hot water or water containing bleach detergents. Do not re-use any part of the test kit. Do not open packets or vial until you are ready to perform the test. Read and follow all instructions carefully before starting the test. Please note: Store in a cool, dry place (below 15-27°C) and away from excess heat and direct sunlight. No MSDS required. Keep away from children and pets. Avoid contact of test areas on strips with skin & eyes, do not ingest or expose to acids. Please read detailed instructions fully before use. Please note: that Watersafe® is a screening test and can not be used to certify water as safe or unsafe for drinking. Watersafe® provides approximate results ONLY when used in strict accordance with instructions. SimplexHealth expressly disclaims any liability resulting from the use of this product, failure to follow instructions, or reliance of test results. This is not a measuring instrument. Wash hands before and after use. Store in a cool, dry (below 32°C) place and away from excess heat and direct sunlight. No MSDS required. Keep away from children and pets. Avoid contact of test areas on strips with skin & eyes, do not ingest or expose to acids. Dispose of used tests responsibly. Made in USA
